TWELITE STAGE BOARD

General

I heard that the manufacturing of the STARTER KIT has ended. Is there an alternative?

We sincerely apologize, but there is no direct replacement.

By combining the TWELITE DIP main unit with a breadboard, you can perform evaluations with greater flexibility.

Configuration to reproduce the main functions of the TWELITE STAGE BOARD

The main functions of the TWELITE STAGE BOARD can be reproduced with the following configuration:

• Our products:
  • 1x TWELITE DIP TWE-L-DI-W
  • 1x TWELITE R2 MW-LITER2
• General-purpose products:
  • 2x breadboards (large type with a long side of 100mm or more recommended)
  • 2+ tactile switches
  • 3+ resistor-embedded LEDs (or LEDs and current-limiting resistors)
  • 1+ potentiometer (10kΩ)
  • Jumper wires (rigid U-shaped) and Dupont wires (soft and long)

Configuration to reproduce the main functions of the STARTER KIT

The main functions of the STARTER KIT can be reproduced with the following configuration:

• Our products:
  • 1x TWELITE DIP TWE-L-DI-W
  • 1x TWELITE DIP TWE-L-DI-U
  • 1x Thin antenna MW-A-P2010
  • 1x Dipole antenna MW-A-D85
    • 1x SMA conversion cable MW-C-UJ-10-1
  • 1x TWELITE R2 MW-LITER2
• General-purpose products:
  • 2x breadboards (large type with a long side of 100mm or more recommended)
  • 4+ tactile switches
  • 6+ resistor-embedded LEDs (or LEDs and current-limiting resistors)
  • 2+ potentiometers (10kΩ)
  • Jumper wires (rigid U-shaped) and Dupont wires (soft and long)

Hardware

What should I do if only some input/output pins do not work?

This may be caused by poor contact on the TWELITE DIP.

Please press the TWELITE DIP firmly. Also consider using the ZIF Socket Attachment Kit.