TWELITE_Apps is a firmware that integrates TWELITE APPS such as the Extremely Simple! Standard App App_Twelite, allowing users to switch functionalities without rewriting. It’s like an assortment pack of TWELITE APPS.It comes pre-installed on TWELITE STICKs at the time of shipment.
Overview
The unified firmware bundles the following TWELITE APPS:
- Extremely Simple! Standard App (App_Twelite)
- Parent and Repeater App (App_Wings)
- Remote App (App_IO)
- Serial Communication App (App_Uart)
- CUE Setting App (App_CUE_OTA)
- ARIA Setting App (App_ARIA_OTA)
Each TWELITE APP operates exclusively and behaves just like its standalone version.
For details on each function, please refer to the description for each TWELITE APP.
Switching involves a reset, but it can be performed from software without rewriting the firmware.
How to Switch
1. Open Interactive Mode
Access the Interactive Mode of TWELITE APPS and enter : (AppSel).
[CONFIG MENU/App_Wings:PARENT:0/v1-03-2/SID=8300051A]
a: (0x67720102) Application ID [HEX:32bit]
c: (18 ) Channel(s)
x: ( 0x03) RF Power/Retransmissions [HEX:8bit]
b: (115200,8N1) UART Baud Alt. [XXXXX]
o: (0x00000000) Option bits [HEX:32bit]
t: (0xA5A5A5A5) Encryption key [HEX: 32bits]
[ESC]:Exit [!]:Reset System [*]:Extr Menu [:]:AppSel
2. Open the TWELITE APPS List
A menu like the following will display a list of TWELITE APPS:
[TWELITE AppSel/v0-02-1/SID=8300051A/SAVE=04-12-01]
M: AppSel App selector (this screen)
R: Revert to DEFAULT(*DEF)
A: App_Twelite Standar app. (App_Twelite)
B: App_IO App for remote. (App_IO)
C: App_UART App for SERIAL comm. (App_Uart)
D: App_Wings Parent/Repeater (App_Wings)(*DEF)
E: App_OTA OTA Apps for ARIA/CUE.
[!]:Reset [R]:Revert [$]:LANG=English
3. Select a TWELITE APP
Just like in Interactive Mode, you can switch to a TWELITE APP by entering the command ID letter.
For example, in the above example, entering C switches to App_Uart.
[App_UART / App for SERIAL comm. (App_Uart)]
Designed for UART (Serial) communications. UART is commonly used on MCUs.
=== Please select from the list below. Save the startup application. ===
1: Normal
2: for TWELITE UART
[BS]:Back
On the switching screen, select a variation if necessary.
After that, the TWELITE APP will switch and reset immediately.
Initialize TWELITE APP
On the TWELITE APP list screen, entering R will revert to the default TWELITE APP.
! Clear Save Data? The next key will perform:
S: Clear App Selection.
!: Clear ALL SAVE DATA.
[BS]:Back
If you enter
S, only the switch will occur. If you enter !, the settings will also be initialized along with the switch.